Are you an Amcrest cheerleader or what? You go out of your way to defend them.Revo2Maxx wrote: ↑Fri Dec 20, 2019 2:49 pm @eklee
Hello and welcome to the Forum...
While I am not going to say this is the issue but have you tried to do another reboot after the update... Also a factory reset is a Expectation after FW update.... Also should Format your MSD...
This week my Camera;'s have been very unhappy with me... I with them lol... However it is my fault my cameras are not happy with me this week that is because even though I have them indoors They are enclosed in windows that are sealed and found they have fallen below the Normal Operating temp range and while they are working they are VERY slow and unhappy lol.... They were driving me crazy and Reset my cameras, My DVR's my PC-NVR, MY Servers and everything.. Then put a Temp Gauge in the area where they are sealed into and found they are VERY cold between 9 and 20 degrees F. When they are running above the 14 or -10c as they are designed to work they are fine...
I have four low resolution Amcrest cameras which work great. I bought an IP3M941 to have a better camera in a specific spot. It was working great before the firmware update. Now, it is sluggish. It won't record 24/7 to the SD card. I've set it to just record motion events now. It won't operate at all at the highest resolution, I've had to lower it to 1080P. Half the time, it doesn't show up on Surveillance Pro, even though it's connected to the router. It shuts off at random times, I have to unplug it and plug it back in and then it works half ass again.
The is the same camera on the same router that was working just fine before the firmware upgrade. I've rebooted it about a dozen times and done half a dozen hard resets.